Analysis of joint test steps between justINA and Guowei
Equiinet's justINA is a converged communications machine that originated in the UK, then became famous in Las Vegas, and later came to China to integrate talent and value.
justINA is a network device based on SIP protocol. It has been connected with many PBX and IPPBX brands at home and abroad. The original investment is guaranteed for the user and meets the needs of the company at this stage of development.
Not only can it be connected to well-known old PBXs such as Huawei, Avaya IPO, Mitel, and Siemens through the SIP protocol. It can also be connected to Panasonic and NEC through the E1 gateway. (Panasonic devices can also add SIP boards for seamless docking via SIP protocol).
In addition to the SIP protocol, E1 gateway, is there any other docking mode? Yes, it is docked through the O-port device.
Recently, based on customer needs, justINA tried to interface with the purely domestic analog PBX Guowei. One is an IP device, and the other is a traditional PBX device. There must be an intermediate device to act as a bridge. Therefore, we "invited" the fast-time 8O port gateway to act as a "bridge" and docked justINA with Guowei machines.
From the above introduction, justINA's compatibility is indeed a bit strong, and can be seamlessly interfaced with analog PBX devices, semi-analog devices, and IP devices. The goal is to preserve the original investment for the user and to meet the new needs of the customer with more functions.
Below, to introduce to you, how is justINA with Guowei from the initial knowledge to the mutual understanding, and then to the interconnection.
1, customer needsThe customer hopes to complete the networking of the three places, but hopes to keep one of the National Power equipment;
justINA should be docked with the analog PBX Guowei to realize the dialing of the justINA extension and the Guowei PBX extension;
justINA can use Guowei's outside line to make local calls;
Guowei PBX can use the justINA outside line to make local calls.
In view of the above requirements, we used the Fast Time 8O port gateway for conversion.
The topology diagram is as follows:
justINA: 192.168.1.219, paragraph 8XX
Fast Time 8O Port Gateway: 192.168.1.218
Guowei: No. 200X, 800X
3, the specific configuration3.1. justINA docked with Guowei to realize extension dialing
3.1.1. justINA configuration
(1) Establish a trunk with the fast time O port gateway
DID number: 8005
Provider: T-box
Hostname: 192.168.1.218
(2) Establish call rules
Rules for configuring the extension number to Guowei
Name: to-GZ-guowei
Pattern:_8XXX
Destination: 8005
Apply call rules:
Name: to-GZ-guowei
Pattern:_8XXX
Destination: 8005
3.1.2. Fast Time O Port Gateway Configuration
(1) SIP configuration
SIP server: 192.168.1.219: 5060
Registration method: registration by line
(2) Configure trunks
Basic Configuration -> Trunk -> Trunk Configuration - Trunk Function:
Access mode of each port: Binding, number: 500 (front desk number)
(3) Configure routing
Dialing and Routing -> Router:
FXO X. ROUTE IP 192.168.1.219:5060 //Incoming route
IP X. ROUTE FXO 1-8/R //Outbound route
3.1.3. Guowei configuration
(1) Extension configuration
Configure the extension 2005-2008 on the 8-port O-line extension line, and insert the analog phone test directly into the 8 extension lines to dial the local 8001-8004 extension.
(2) Line connection
The port of 2005-2008 is directly connected to the external port of the 8O port.
After the above configuration is completed, the justINA extension calls 8005 and the Guowei 8005 extension rings;
Guowei 8005 extension calls 2005, will hear the front desk tone, and then dial the extension number 80x, then the extension 80x on the justINA ring.
3.2. justINA passed through Guowei
JustINA exhaled through Guowei’s outside line
Name: use-guowei-out
Pattern:_9. //justINA extension starts with 9 and represents the exit from Guowei
Destination: 8005
Figure 3.2.2
After the above configuration is completed, the justINA extension can be out of the outside line of Guowei by adding the prefix 9.
3.3. Guowei extension is out through the justINA outside line
Because Guowei is an analog PBX, it can't be configured internally; if you want Guowei system to call through justINA, you can only use the extension number to dial, dial to justINA, and then use the second dial to call out on justINA, so we use Go to the DISA feature.
3.3.1. Configuring DISA on justINA
Search PBX feature extensions
Modify the DISA code as follows:
Name:DISA //System default
Number: *3472 //System default
Action:DISA(78,dp_554-dialplan) //The password is 78, and the outside line with 554 extension is out.
Specify the outgoing line for the 554 extension number; when the configuration is complete, when the national number is called
Configure the foreground menu as follows:
After the above configuration, Guowei extension 8005 calls 2005 to hear the foreground tone, then select DISA button such as 4; will hear a long beep, press the password 78# at this time; will hear the long beep again, and then input the corresponding The number so that an outbound call can be made.
4. TestingFrom the above steps, we successfully completed the connection between justINA and Guowei. To this end, we conducted the following tests:
a) justINA extension 801 calls Guowei extension 8005:
a) 801 calls 8005 success;
b) justINA extension 801 uses the National Express line out call 130515156xx:
a) 801 calls 9130515156xx successfully;
c) Guowei extension number 8001 calls justINA extension number 801:
a) 8001 calls 2005, first arrive at the front desk, press 801 to success after hearing the tone of the front desk;
d) Guowei extension number 8001 uses the justINA line to call out:
8001 calls 2005, first arrive at the front desk, press 4 (DISA) after hearing the prompt, hear the beep 78#, hear the phone number to make an outgoing call.
Gas Generating Set,Stable Performance Gas Generator,Gas Generating Set,Continuous Running Generator
Shaoxing AnFu Energy Equipment Co.Ltd , https://www.sxanfu.com